Buzzer - PC Mount 12mm 2.048kH

Buzzer - PC Mount 12mm 2.048kH

Arduino Pro 328 - 5V/16MHz

Arduino Pro 328 - 5V/16MHz

LiPower Shield

299,00 kr 239,20 kr
I lager
Fåtal i lager: 5 st
SKU
DEV-10711
  • Köp 5 för 291,53 kr 233,22 kr st och spara 3%
  • Köp 10 för 284,05 kr 227,24 kr st och spara 5%
Is there anything an Arduino can't do? Well, for one, most of them can't be powered directly from a 3.7V LiPo battery; much less charge and monitor that battery. The LiPower Shield takes care of this by combining the functionality of two of our favorite battery power boards: the Power Cell and the Fuel Gauge.

The LiPower Shield allows you to connect a 3.7V single cell Lithium polymer battery which it will boost up to 5V and connect to the Arduino board's 5V pin. The on-board MAX17043G+U IC is connected to the I2C lines (A4 and A5) so that your project can monitor it's own power supply. The configurable alert interrupt pin on the MAX17043G+U IC is broken out to D3 which will activate when the LiPo gets to 32% or lower.

The charging circuit is configured to charge the LiPo at 100mA but by adding a resistor to the supplied through-holes you can boost this to 500mA. There is a mini-USB port on the shield which allows you to charge the battery from a USB power source or you can supply a separate regulated 5V source on the "charge" header.

Note: We've decided to leave the power indicator LED (LED1) and its current limiting resistor (R3) off this board, as they were producing a significant drain on the battery. Please be aware that your board will have a few, shiny, unpopulated pads.

Note: There is a known hardware bug that will allow the LiPo to discharge below the point where the charging circuit will revive it. Thanks to the on-board fuel gauge, however, some clever programming could keep your project from draining the battery as it gets too low.
Mer information
Artikelnr DEV-10711
Annan benämning N/A
Infolänkar N/A
Short Description N/A
Skriv din egen recension
Du recenserar:LiPower Shield