SGP30 Air Quality Sensor BoB - VOC & eCO2

SGP30 Air Quality Sensor BoB - VOC & eCO2

Nova PM sensor SDS011

Nova PM sensor SDS011

DHT22 Temperature/Humidity Sensor

59,00 kr 47,20 kr
I lager
  • Köp 5 för 53,10 kr 42,48 kr st och spara 11%
  • Köp 10 för 50,15 kr 40,12 kr st och spara 16%

The DHT22 is a basic, low-cost digital temperature and humidity sensor. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air, and spits out a digital signal on the data pin (no analog input pins needed). Its fairly simple to use, but requires careful timing to grab data. The only real downside of this sensor is you can only get new data from it once every 2 seconds, so when using our library, sensor readings can be up to 2 seconds old.

Simply connect the first pin on the left to 3-5V power, the second pin to your data input pin and the right most pin to ground. Although it uses a single-wire to send data it is not Dallas One Wire compatible! If you want multiple sensors, each one must have its own data pin.

We have a Adafruit Learning System guide with schematics, Arduino & CircuitPython code, datasheets and more!

Compared to the DHT11, this sensor is more precise, more accurate and works in a bigger range of temperature/humidity, but its larger and more expensive.

Comes with a 4.7K resistor, which you will want to use as a pullup from the data pin to VCC.


  • Low cost
  • 3 to 5V power and I/O
  • 2.5mA max current use during conversion (while requesting data)
  • Good for 0-100% humidity readings with 2-5% accuracy
  • Good for -40 to 80°C temperature readings ±0.5°C accuracy
  • No more than 0.5 Hz sampling rate (once every 2 seconds)
  • Body size 27mm x 59mm x 13.5mm (1.05" x 2.32" x 0.53")
  • 4 pins, 0.1" spacing
  • Weight (just the DHT22): 2.4g

Mer information
Artikelnr K-DHT22
Annan benämning N/A
Infolänkar N/A
Short Description AM2302
Skriv din egen recension
Du recenserar:DHT22 Temperature/Humidity Sensor
Fler produkter du kan vara intresserad av